Pilz PSSu E S 2DO 2-T Instrukcja Użytkownika Pobierz pdf (Strona 25)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

6-1

6.1 General wiring guidelines

6 Wiring

66000WiringWiring6-6.1General wiring guidelines6100General wiring guidelines6-][Verdrahtung BA Einleitung

Please note:

][Verdrahtung ST-Ausgang

 The actuators may be connected using unshielded cables.

 The outputs do not need suppression for inductive loads.

 Use copper wiring.

][Verdrahtung Zusatz mit C

 The terminal configuration as stated on the front plate applies for base

modules with C-rail. The terminal configuration as stated in the tech-

nical documentation applies for all other base modules.

6.1.1 Mechanical connection of the base modules

Mechanical connection of the base modules6-][Modulverdrahtung mech

Procedure:

 Use a flat blade screwdriver (DIN 5264-A)!

 Strip the wire back 8 mm.

 If necessary, label the connection level with a colour marker [3].

 Base module with screw terminals:

– Use a screwdriver to loosen the screw on the screw terminal [1]

– Insert the stripped cable into the round fixing hole [2], as far as it

will go.

– Tighten up the screw on the screw terminal.

– Check that the cable is firmly seated.

 Base module with cage clamp terminals:

– Insert the screwdriver [4] into the square hole [1].

– Insert the stripped cable into the round fixing hole [2], as far as it

will go [5].

– Pull out the screwdriver [6].

– Check that the cable is firmly seated.

DIN 5264-A

2111

[1]

[3]

[2]

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 34 35

Brak uwag

Pilz PSSu E S 2DO 2-T Instrukcja Użytkownika Strona 25